Alfa level M3 - Multi-Pass; Identification of Plate Side

Description
Multi-pass
Multi-passcanbecreatedbyusingturningplates,with1,2or3unholedports.Themain
purposeistochangetheowdirectionofoneorbothuids.
Forsomeunitspartitionplateisrequiredtosupporttheunholedportsintheturningplates.Also
transitionplateneedtobeaddedinthepackagetopreventmediatogetincontactwiththe
partitionorpressureplate.
Exampleofuseformulti-passcanbeinprocessesthatrequireslongerheatingperiodsifthe
mediarequiresaslowerheating.
Channel plates
Cold in
Hot out
Hot in
Cold out
End Plate I
End Plate II
Channel plates Transition plate
Turning Plate
Figure3.Exampleofmulti-passsetup.
Identicationofplateside
TheAsideoftheplateisidentiedbythestampwiththeletterAorthemodelname,insome
casesboth,atthetopoftheplate(refertogure).
DocumentIDLanguageEdition
10InstructionManual-PlateHeatExchangers3490010217EN2014-11