Replacing the display back-cover
and antenna assembly
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your
computer, follow the instructions in After working inside your computer.
For more safety best practices, see the Regulatory Compliance home
page at
www.dell.com/regulatory_compliance.
Procedure
1 Place the display back-cover and antenna assembly on a clean and flat
surface.
2 Adhere the display cable, logo-board cable, and camera cable to the display
back-cover and antenna assembly.
Post-requisites
1 Replace the display hinges.
2 Replace the display panel.
3 Replace the logo board.
4 Replace the camera.
5 Replace the display bezel.
6 Replace the display assembly.
7 Follow the procedure from step 2 to step 15 in “Replacing the system board”.
8 Replace the memory modules.
9 Replace the battery.
10 Replace the computer base.
11 Replace the rear-I/O cover.
12 Replace the solid-state drive.
13 Follow the procedure from step 4 to step 6 in “Replacing the hard drive”.
14 Replace the wireless card.
120
To Next Page
Loading...
