Replacing the tobii eye-tracker
module
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your
computer, follow the instructions in After working inside your computer.
For more safety best practices, see the Regulatory Compliance home
page at
www.dell.com/regulatory_compliance.
Procedure
NOTE: After replacing the Tobii eye-tracker module, launch the EyeX
application with internet connection to update the firmware
automatically.
Using the alignment posts, place the tobii eye-tracker module on the display bezel
and snap it into place.
Post-requisites
1 Follow the procedure from step 2 to step 4 in “Replacing the display bezel”.
2 Replace the display assembly.
3 Follow the procedure from step 2 to step 15 in “Replacing the system board”.
4 Replace the computer base.
5 Replace the rear-I/O cover.
6 Replace the memory modules.
7 Replace the solid-state drive.
8 Replace the wireless card.
9 Follow the procedure from step 4 to step 7 in “Replacing the hard drive”.
10 Replace the base cover.
99
To Next Page
Loading...
