36 | Setting up the monitor
Removing the monitor stand
NOTE: To prevent scratches on the display when removing the stand,
ensure that the monitor is placed on a soft, clean surface.
NOTE: The following instructions are applicable only for removing the
stand that was shipped with your monitor. If you are removing a stand
that you purchased from any other source, follow the setup instructions
that were included with the stand.
To remove the stand:
1. Tur
n off the monitor.
2. Disconnect the cabl
es from the computer.
3. Plac
e the monitor on a soft cloth or cushion.
4. C
arefully slide and remove the I/O cover from the monitor.
5. Disconnect the cables from the monitor and slide them out through the
cable-management slot on the stand riser.
To Next Page
Loading...
