Operating the monitor | 57
OSD warning message
When you adjust the Brightn
ess level above the default level for the first time,
the following message appears:
NOTE: If you select Yes, the message will not appear the next time you
changes the Brightness setting.
When you change the default setting of pow
er saving features for the first time,
such as Eco Mode or Preset Modes, the following message appears:
NOTE: If you select Yes for either of the features mentioned above, the
message will not appear the next time you change the settings of these
features. When you perform a factory reset, the message will appear
again.
When the monitor goes into Standby mode, the
following message appears:
When Eco Mode is On
To Next Page
Loading...
