Operating the monitor | 65
When the monitor goes into Standby mode, the
following message appears:
Activate the computer and wake up the monitor to gain access to the OSD.
The OSD functions only in the normal oper
ation mode. If you press the joystick
during the Standby mode, the following message will appear depending on the
selected input:
Activate the computer and wake up the monitor to gain access to the OSD.
NOTE: The message may be slightly different according to the connected
input signal.
If DisplayPort or HDMI input is selected and the corresponding cable is not
connected,
the following message will appear:
NOTE: The message may be slightly different according to the selected
input signal.
Activate the computer and wake up the monitor to gain access to the OSD.
To Next Page
Loading...
