ALLEN & HEATH XONE:96 User Manual

ALLEN&HEATH 22 AP11645_1_XONE:96 User Guide
REAR PANEL CONNECTORS continued
MIC A / MIC B Inputs
Use superior quality low impedance dynamic mics. Do NOT use high impedance or unbalanced mics,
or condenser mics requiring phantom power.
NOTE: XONE:96 implements a ‘clean feed’ bus for MIC inputs; by default MIC A and MIC B inputs do
not route to the BOOTH outputs and are unaffected by MASTER INSERT hardware processing.
Balanced XLR, wired; Pin1=Ground, Pin2=Hot [+], Pin3=Cold [-]
10
SND 1 / SND 2, LINE Outputs
Connect your external FX inputs to SND 1 or SND 2 outputs and use SEND 1 / SEND 2 controls to
send Channel audio to the FX unit. Connect MONO devices via L/M.
Switchable SND 1 input and RTN A output impedance for external FX between LN, or Hi-Z suitable for
guitar FX pedals or legacy hardware.
Balanced (TRS) ¼“Jack, wired; Tip=Hot [+], Ring=Cold [-], Sleeve=Ground.
19
K-Slot
Security slot to connect locking, Kensington® type, anti-theft cable.
11
AC Mains Input
Connect (supplied) IEC cable with moulded plug compatible to local AC mains supply.
Turn AC supply to the mixer ON/OFF.
12
MST 1, MASTER Outputs
Main stereo LR MIX outputs that feed the club PA system, or active speakers.
Balanced XLR, wired; Pin1=Ground, Pin2=Hot [+], Pin3=Cold [-]
13
MASTER INSERT SND / RTN
Provides INSERT points for the MST1 outputs to connect hardware dynamics processors such as a
limiter, compressor, or graphic equaliser. Or when connecting effects hardware in-line with the
(MST1) LR MIX output for external MASTER INSERT FX. Insert devices do not affect MIC A/B inputs.
INSERT SND: Balanced (TRS) ¼“Jack, wired; Tip=Hot [+], Ring=Cold [-], Sleeve=Ground.
INSERT RTN: Unbalanced (MONO) ¼”Jack, wired; Tip=Hot [+], Sleeve=Ground.
14
MST 2 Outputs
Alternative stereo LR MIX output to feed additional zone, consumer amplifier, or active speakers.
Balanced (TRS) ¼“Jack, wired; Tip=Hot [+], Ring=Cold [-], Sleeve=Ground.
15
BOOTH Outputs
Dedicated, balanced LINE level stereo output feed to DJ’s local monitor PA system, or active speakers.
Balanced (TRS) ¼“Jack, wired; Tip=Hot [+], Ring=Cold [-], Sleeve=Ground.
16
RTN C / RTN D, Auxiliary Return Inputs
Connect auxiliary LINE level music sources, or external effects outputs to route direct to LR MIX.
Connect MONO devices via the L/M socket.
Use RTN C / RTN D top panel controls to adjust signal levels sent to the LR MIX.
Unbalanced (MONO) ¼“Jack, wired; Tip=Hot [+], Sleeve=Ground.
17
RTN A / RTN B, LINE Inputs
Connect auxiliary LINE level music sources, or external effects device outputs to RTN A and RTN B
LINE inputs to route to CH A and CH B. Use L/M sockets when connecting MONO and Hi-Z devices.
Balanced (TRS) ¼“Jack, wired; Tip=Hot [+], Ring=Cold [-], Sleeve=Ground.
18

ALLEN & HEATH XONE:96 Specifications

General

Channels quantity	8 channels
Digital sound processing	- bit
Equalizer bands quantity	4
DJ mixer	-
Product color	Black, Grey
USB connector type	USB Type-B
Master (XLR) out	1
Headphone connectivity	3.5 mm/6.35 mm
Number of microphone inputs	2
AC input voltage	100 - 240 V
AC input frequency	50/60 Hz
Power consumption (typical)	45 W
Built-in display	No

Weight and Dimensions

Depth	410 mm
Width	336 mm
Height	109 mm
Weight	7000 g