ALLEN & HEATH XONE:96

ALLEN&HEATH 30 AP11645_1_XONE:96 User Guide
TIMECODE SETUP - TRAKTOR SCRATCH PRO
This section explains how to configure the XONE:96 DJ Mixer to control playback via timecode from an external
turntable or CD player when using TRAKTOR SCRATCH PRO.
• Ensure TRAKTOR SCRATCH PRO is installed and activated on your computer
NOTE: TRAKTOR PRO 2 does not support timecode control.
• Ensure that your XONE:96 DJ Mixer is connected to the computer via USB 1 or USB 2.
• Connect turntables or CDJ media players to the LINE / PHONO Inputs on the XONE:96.
• Set the USB LN/PH switches on the XONE:96 rear panel for turntables or CDJ media players.
e.g. Switch in to PH for use with turntables. Switch out to LN for use with CDJ media players.
• Next, on the XONE:96 top panel; set corresponding CH1 - 4 Input Select Switches to USB 1 or USB 2.
• Next, in TRAKTOR SCRATCH PRO; open Preferences
• Select the Audio Setup dialogue
• Check, or select XONE 96 as the Audio Device
macOS: XONE 96 USB 1, or XONE 96 USB 2 ¦Windows: XONE 96 ASIO Driver*
*ASIO is a trademark and software of Steinberg Media Technologies GmbH