ALLEN&HEATH 25 AP11645_1_XONE:96 User Guide
DRIVER INSTALLATION (PC) continued
• This may take some time to complete.
• Please wait while XONE:96 v4.43.0 software is installed…
• Click Install If promoted to install Allen&Heath Sound, video and game controllers software.
• Click Install if prompted to install Allen&Heath XONE:96 Audio Devices software.
• Connect the XONE:96 mixer to your PC via the USB 1, or USB 2 port and power the unit ON*.
• Click Next to continue once the pre-installation process has completed.
• Click Finish to complete the Device Driver installation.
• NOTE:
It is possible to run the XONE:96 Device Driver pre-installation process without connecting the
XONE:96 mixer to your computer.
In this case you will be prompted to “...disconnect and reconnect the device to complete driver
installation.”
If the mixer cannot be connected, click Yes on the prompt to close the application.
To complete installation, connect the XONE:96 to your PC via USB, power the mixer ON.
Wait a few moments for the PC to enumerate the mixer before opening your software application.