ALLEN&HEATH 28 AP11645_1_XONE:96 User Guide
MIDI CONTROL continued
MIDI CONTROL
XONE:96 CHANNEL
MIDI VALUES
VALUE [HEX] 1 2 3 4 A B C D VCF 1 VCF 2 LR MIX MUTE NOTE/CC CH# OUT IN
CH SOURCE*
NOTE*
16
CH FADER
00 01 02 03
CC
16
CH CUE
00 01 02 03 04 05 06 07
NOTE
16
HPF
0A 0E
NOTE
16
BPF
0B 0F
NOTE
16
LPF
0C 10
NOTE
16
ON / OFF
08 09 0D 11
12
NOTE
16
PHONES 2 2B 2C 2D 2E 2F 30 31 32
33
NOTE
16
XFADER
05 CC
16
*
CH IP SOURCE MIDI VALUES [HEX]
USB 1
13 17 1B 1F 23 27
NOTE
16
PHONO
14 18 1C 20
NOTE
16
LINE
15 19 1D 21
NOTE
16
MIC A
24
NOTE
16
MIC B
28
NOTE
16
RTN A
25
NOTE
16
RTN B
29
NOTE
16
USB 2 16 1A 1E 22 26 2A
NOTE
16
MIDI Channel Setup
The default XONE:96 MIDI Channel is 16, but can be changed to any channel between 1 and 16 when powering
the mixer ON. To change the channel number:
• Press and hold down both MIDI 1 and MIDI 2 switches
• Power the XONE:96 mixer ON
CH A/ B /1-4 CUE, and FILTER 1/ FILTER 2 HPF Filter Type Select switches blink slowly
• Press the corresponding CUE or HPF switch to select the required MIDI channel between 1 and 8*
NOTE: To access MIDI CH 9 - 16:
• Push the FILTER 1 or FILTER 2 ON/OFF switch once.
CH A/ B /1-4 CUE, and FILTER 1/FILTER 2 HPF Filter Type Select switches blink rapidly
• Press the corresponding CUE or HPF switch to select the required MIDI channel between 9 and 16*
*
CUE A = MIDI CH 1 or 9 ¦ CUE B = MIDI CH 2 or 10 ¦ F1 HPF = MIDI CH 3 or 11 ¦ CUE 1 = MIDI CH 4 or 12
CUE 2 = MIDI CH 5 or 13 ¦ CUE 3 = MIDI CH 6 or 14 ¦ CUE 4 = MIDI CH 7 or 15 ¦ F2 HPF = MIDI CH 8 or 16
• After the CUE or HPF switch is pressed, the switches stop blinking and Filter Type Select switch LEDs
cascade to indicate the MIDI channel change is implemented.
NOTE: The new MIDI channel remains stored when the mixer is powered OFF and is recalled on subsequent
power-cycles until any further change is made.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
