Allen-Bradley 1734-OE2V - Placing Series C Analog Current Output Modules

18 POINT I/O 2 Current Output and 2 Voltage Output Analog Modules
Publication 1734-IN002E-EN-E - October 2016
Placing Series C Analog Current Output Modules
Always install modules in accordance with their specified operating temperature ratings, as
listed in Environmental Specifications
on page 20, and provide a minimum of
2.54 cm (1.0 in.) clearance above the modules.
Specifications
Flashing Green Channel is being calibrated.
Flashing Red Open wire or no field power is present. A low or high clamp is present.
Red — No field power is present.
Output Specifications
Output Specifications 1734-OE2C 1734-OE2V
Number of Outputs 2 single-ended, non-isolated,
current
2 single-ended, non-isolated,
voltage
Resolution 13 bits - over 0-21mA
2.5μA/cnt (average value -
typical range:
2.3...2.7μA/cnt)
14 bits
(13 plus sign)
1.28mV/cnt in unipolar or bipolar
mode
Output Current 0 mA output until
communication established
4...20 mA user configurable
0...20 mA user configurable
—
Output Voltage — 0V output until communication
established
0...10V (user configurable)
(-0.0V under, +0.5V over)
+
10V user configurable (-0.5V under,
+0.5V over)
Absolute Accuracy
(1)
0.1% full scale @ 25
o
C
Accuracy Drift w/Temp. 30ppm/
o
C5ppm/
o
C
Step Response to 63% of FS 24 μs
Channel Status
Indication Probable Cause
1734-OE2C
Probable Cause
1734-OE2V