Allen-Bradley ControlLogix 1756-OF4 - Page 12

12 ControlLogix Voltage/Current Output Module
Publication
1756-IN016B-EN-P - November 2003
2. Connect the insulated wires to :
• the RTB (as shown below) if the cable is grounded at the
field device.
or
• the field device if the cable is grounded at the chassis.
20863–M
Spring Clamp RTB
A. Strip 7/16 inch (11mm) maximum
length of wire.
B. Insert the screwdriver into the
inner hole of the RTB.
C. Insert the wire into the open terminal
and remove the screwdriver.
NEMA Screw RTB
A. Strip 5/16 inch (8mm) maximum length
of wire.
B. Turn the terminal screw counterclockwise.
C. Insert stripped end of wire under plate on
the terminal.
D. Turn the terminal screw clockwise until
wire is secured.
42516