Rockwell Automation Publication 1756-UM001M-EN-P - February 2012 51
Start Using the Controller Chapter 3
c. Click Auto-Configure.
6. If the auto configuration is successful, click OK.
If the auto configuration is not successful, verify that the correct Comm
Port was selected.
7. Click Close.
Upgrade Controller Firmware
You may choose to upgrade controller firmware by using either of these tools:
• ControlFLASH™ software packaged with RSLogix 5000 software
• AutoFlash feature of RSLogix 5000 software
To upgrade your controller firmware, complete the appropriate tasks listed in this
table.
 Task Page
Determine Required Controller Firmware 52
Obtain Controller Firmware 53
Use ControlFLASH Utility to Upgrade Firmware 53
Use AutoFlash to Upgrade Firmware 56
To Next Page
Loading...
Need help?
General
