10 Rockwell Automation Publication 842E-UM001C-EN-P - September 2016
Chapter 1 Safety
necessary to comply with the EtherNet/IP specifications and guidelines for
installing an EtherNet/IP network. If any modifications are made to the 842E
EtherNet/IP encoder, any warranty claim against Rockwell Automation is
rendered void.
General Safety Notes and
Protective Measures
Environmental Protection
Note the following information on disposal.
ATTENTION: Observe the following procedures to confirm the correct and
proper use of the 842E EtherNet/IP encoder.
Qualified personnel with knowledge of electronics, precision mechanics, and
control system programming install and maintain the encoder. It is necessary to
comply with the related standards for the technical safety stipulations.
All persons who install, operate, or maintain the device have to meet the safety
regulations:
• The operating instructions must always be available and must always be
followed.
• Unqualified personnel are not allowed to be present in the vicinity of the
system during installation.
• The system is to be installed in accordance with all applicable safety
regulations and the mounting instructions.
• All work safety regulations of the applicable countries are to be followed
during installation.
• Failure to follow all applicable health and safety regulations results in
personal injury or damage to the system.
• The current and voltage sources in the encoder are designed in accordance
with all applicable technical regulations.
Assembly Material Disposal
Packaging Cardboard Waste paper
Shaft Stainless steel Scrap metal
Flange Aluminum Scrap metal
Housing Aluminum Die-cast Scrap metal
Electronic assemblies Various Hazardous waste
To Next Page
Loading...
