Publication 2711P-UM001A-EN-P
Using Configuration Mode 4-7
RSLinx Communications
The RSLinx Communications screen shows a treeview of installed
communication cards and network configurations. You can:
• edit/view the driver settings for the communication protocol
used by your .MER application.
• edit the device address of the controller on the network.
The procedure for editing these settings is the same regardless of the
communication protocol. The only differences are the properties for
each communication protocol and the device address of the logic
controller. The properties for each communication protocol are
defined immediately after this section.
Terminal Settings
Networks and Communications
RSLinx Communications
Communication Driver
Ethernet Driver
AB PLCs
To Next Page
Loading...
