Name: Allen-Bradley PanelView Plus 1000
Brand: Allen-Bradley
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Publication 2711P-UM001A-EN-P

5-10 Installing and Replacing Components

5. Carefully lift the Logic Module away from the terminal and flip

over to expose the circuit board.

6. Locate the battery on the circuit board.

7. Press down firmly on the middle part of battery retainer clip.

The battery will pop out.

8. Slide the new battery under the 3-prong holder and push down.

9. Attach the Logic Module by aligning the 2 connectors on the

bottom of the module align with the connectors on the terminal.

10. Push down on the Logic Module until firmly seated.

11. Tighten the 6 captive screws that secure the Logic Module to a

torque of .68 N•m (6-8 in-lb).

12. Attach the Communication Module (if necessary) and tighten the

4 screws to a torque of .68 N•m (6-8 in-lb).

IMPORTANT

Wear a properly ground ESD wristband

before touching any of the electronic

components in the Logic Module.

Battery

Press down

here to pop

battery out.

Other manuals for Allen-Bradley PanelView Plus 1000

Questions and Answers:

Need help?

Do you have a question about the Allen-Bradley PanelView Plus 1000 and is the answer not in the manual?

General