allen SSE12 - Page 24

SECTION 1
SAFETY
050362Page 24
ALWAYS keep the machine in proper running condition.
Fix damage to machine and replace any broken parts immediately.
ALWAYS inspect your screed upon arrival for damage or tampering that can sometimes occur durring shipping. If damage
isfound,leaclaimwithyourcarrierImmediately!! Mark freight bill of ladding as “damaged shipping”
ALWAYS store equipment properly when it is not being used. Equipment should be stored in a clean, dry location out of the
reach of children and unauthorized personnel.
ENGINE SAFETY
DO NOTplacehandsorngersinsideenginecompartmentwhenengineisrunning.
NEVER operate the engine with heat shields or guards removed.
Keepngers,handshairandclothingawayfromallmovingpartstopreventinjury.
ALWAYS disconnect spark plugs before servicing engine to prevent accidental start-up.
DO NOT remove the engine oil drain plug while the engine is hot. The possibility of hot oil exists which could cause severe
scalding.
NEVERtouchthehotexhaustmanifold,muferorcylinder.Allowthesepartstocoolbeforeser-
vicing equipment.
ALWAYS be aware of HOT components on this machine, such as, Hydraulic
components.
NEVERrunenginewithoutanairlterorwithadirtyairlter.Severeenginedamagemayoccur.Serviceairlterfrequently
to prevent engine malfunction.
NEVER tamper with the factory settings of the engine or engine governor. Damage to the engine or equipment can result if
operating in speed ranges above the maximum allowable.
General Safety, continued