AM81687-A
Original Instructions – English
18
Height of cut adjustment
The height of cut is set by altering the position of the front roller. Two adjusters are provided to level
the front roller.
Turn the height of cut adjustment knob clockwise to lower the height of cut
Turn the height of cut adjustment knob anti-clockwise to raise the height of cut
Use of the height bar
It is recommended to use a height bar to accurately measure the height of cut on each side of the
mower. To do this proceed as follows:
WARNING - blades are sharp, always wear gloves
For a cutting cylinder cartridge:
1) Set “on cut” first, refer to section below
2) Adjust and lock the bolt on the height setting bar to your desired height of cut
4) Tilt the mower back and wedge securely
5) With the height setting bar near one end of the bottom blade, locate the bolt head on top of the
bottom blade and under the rear roller
6) Adjust the front roller so that it makes contact with the height setting bar
7) Move the height setting bar to the other end of the bottom blade and repeat steps 5 & 6
To Next Page
Loading...
