Alliance Laundry Systems AR105M X CONTROL - Machine Installation on Floor or Steel Base

Machine Installation on Floor or Steel Base
The drum of rigid-mount machines is fixed to the frame. The
floor and steel base (if used) underneath the machine MUST be
stable enough to be able to absorb the dynamic loads which are
created during the spin sequence. Refer to General Specifica-
tions. M16 anchor bolts and washers (60mm external diameter,
16.5mm internal diameter
, 6mm thickness) and M16 self-locking
nuts must be used so the machine, the steel base (if used) and
floor form one integral unit. Refer to Figure 8 and Figure 9 .
NOTE: Anchor bolts are not supplied with machine.
Washers and nuts are supplied with machines. Torque
is 100Nm. For anchoring dimensions, refer to Mounting
Bolt Hole Locations
CAUTION
To avoid installing the machine in such a way that
may lead to the machine becoming damaged during
operation, be sure to use the nuts and washers sup-
plied with the machine during installation.
North American Models: Mounting bolts must meet the follow-
ing requirements:
• 5/8 in. diameter x 6 in. length
•
5 SAE grade
• 16 thread
• Torque to 100Nm
NOTE: For installations using SAE thread style mount-
ing bolts, SAE thread style nuts with a minimum grade
of 5 must be used.
CAUTION
To avoid installing the machine in such a way that
may lead to the machine becoming damaged during
operation, be sure to use the nuts and washers sup-
plied with the machine during installation.
Installation on floor
CHM2471N_SVG
6
5
4
3
2
1
1. Nuts M16; supplied with the machine
2. Washers; 60mm external diameter, 16.5mm internal diameter, 6mm thickness; supplied with the machine
3. Spacing washer
4. Anchor bolt
5. Washing machine
6. Concrete floor
Figure 8
Installation
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
33 Part No. D1599ENR16