Every 6 Months
1. Clean the water valve filters.
a. T
urn off the water supply.
b. Unscrew the hoses at the back of machine.
c. Take out filter at center with pointed pliers.
d. Clean the filter and re-insert.
e. When reattaching the hoses, make sure the seals are seated
correctly.
f. Check water inlets for leaks.
g. Tighten the connections or replace the seals of inlet hose if
necessary.
2. If machine is fitted with a drain pump, make sure the pump
provides normal flow rate during draining. The drain pump
can be cleaned when it becomes clogged with foreign objects.
a. Drain all water from machine.
b. Disconnect machine from power supply.
c. Remove the front panel of cabinet by unlocking bolts. Re-
fer to Figure 39 .
1. Bolts
2. Pump lid
Figure 39
d. Slightly turn the pump lid until water starts flowing out,
making sure to catch the water.
e. Unscrew the lid and remove any foreign objects.
f. Reattach pump lid and front panel of cabinet.
3. Remove dust or dirt and verify functionality of the following:
a. Inverter cooling fin
b. Motor cooling fins
c. Interior inverter ventilator (if present)
d. Exterior inverter ventilator (if present)
IMPORTANT: All torque joints must remain dry
(non-lubricated).
4. Check for belts for wear and inspect tightness. For recom-
mended values, refer to Table 41 .
Model
New belt,
Torque, Hz
Run-in belt,
Torque, Hz
7.5 kg / 20 lb. /
75 L
88 - 98 88 - 92
10.5 kg / 25 lb. /
105 L
62 - 67 60 - 62
13.5 kg / 30 lb. /
135 L
73 - 78 70 - 73
18 kg / 40 lb. /
180 L
56 - 61 54 - 56
24 kg / 55 lb. /
240 L
63 - 73 66 - 68
28 kg / 70 lb. /
280 L
80 - 86 77 - 80
35 kg / 80 lb. /
332 L
59 - 66 56 - 60
52 kg / 120 lb. /
520 L
68 - 75 65 - 68
Table 41
5. Check the tightness of bolts. Refer to Table 42
.
Item
Bolt
Type
T
orque, lb.
ft. [Nm]
Door lock bolts M5 1.84 [2.5]
Door handle central bolt M6 6.49 [8.8]
Door hinge and front panel
bolts
M6 6.49 [8.8]
Anchoring bolts M16 73.76 [100]
External tub bolts M8 19.18 [26]
Motor bolts M12 N/A
Table 42
6. Check the door pressure and inspect the door seal. Replace it
as needed. Refer to instructions 4-18-215 for door pressure
adjustment and door seal replacement details.
7. After a cycle has been completed, check the shock absorbers
to see if they are warm. If the shock absorbers aren’
t warm
just after a wash cycle has been completed, replace them.
Emergency Unblocking of Door Lock
NOTE: Read Important Safety Instructions first.
1. V
erify if all condition are present to safely open the door.
2. Remove front panel.
Maintenance
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
73 Part No. D1599ENR16
To Next Page
Loading...
