Installation
Part No. 70458301ENR7
©
Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT 43
1
Front Panel Screw
2
Front Panel
3
Control Panel
4
Control Assembly Screw
5
Control Assembly
6
Lint Panel
Figure 8
4. Remove four front panel screws. Refer to Figure 8 . Keep
door hinge cams in place on door hinge lug. Pull lug and
door assembly off as one piece. Refer to Figure 9 .
5. Remove remaining front panel screws. Refer to Figure 8 .
Disconnect door switch harness from switch. Take off front
panel. Refer to Figure 9 .
6. Exchange switch and plug locations. Depress tabs with
an adjustable pliers to remove plug and switch from front
panel. Reinstall switch, orienting button toward center of
machine. Reinstall plug in switch’s previous location. Refer
to Figure 9 .
1
Plug
2
Switch
3
Door Hinge Lug
4
Door Assembly
5
Side Screw
Figure 9
7. Cut wire ties to remove door switch harness bundle. Be
careful not to damage harness wires. Refer to Figure 10 .
8. Reroute door switch harness up through the hole in the
right side of the top panel. Use the panel cutout opening to
then put harness down through the hole in the left side of
the top panel and into the upper left corner of the cylinder
enclosure.
To Next Page
Loading...
