What to do if Alliance Laundry Systems Dryer control is in lockout mode?
If the control is in lockout mode, a manual reset is needed. You can reset it by pushing the red lockout button or using the front end control.
What to do if Alliance Laundry Systems Dryer has valve on, but no spark during TFI?
Several issues could be the cause: * A shorted electrode. * The spark gap might not be correct. If so, set it to .094-.156 inch. * The high voltage cable might be faulty or have a poor connection. * A control failure.
Why Alliance Laundry Systems Dryer has thermostat on, but no spark or valve?
If the thermostat is on, but there's no spark or valve activity, check the red LED for steady on or flashing codes. This could be due to the cable connecting to the control and electrode, or voltage present at the gas valve or a bad control.
What to do if Alliance Laundry Systems Dryer has spark on, but no flame?
If there's a spark but no flame, consider these possibilities: * Check if the gas is turned on. * Ensure there's 24 VAC at the gas valve. * There could be a bad control. To check this, measure the voltage between the gas valve terminal MV and GND on the control.
What to do if Alliance Laundry Systems Dryer has flame okay during TFI, but no flame sense after TFI?
If the flame is okay during TFI (Trial for Ignition) but there's no flame sense afterward, consider the following: * Check the electrode position and cleanliness. * Inspect the high voltage wire. * Ensure there's a good ground at the burner. * Check for a poor flame and verify the flame current.
What to do if Alliance Laundry Systems Dryer reset failure?
If you're experiencing a reset failure, here are a couple of things to try: * If the reset switch was pressed too long, try to reset again. * If the reset switch is shorted, replace it.
General| Brand | Alliance Laundry Systems |
|---|---|
| Model | CA170L |
| Category | Dryer |
| Type | Commercial |
| Phase | 1 or 3 |
| Heating Source | Electric |
| Voltage | 208-240 V |
To Next Page
