Alliance Laundry Systems CHD25G2-CT025L - Required for CE Models Only

Installation
46
©
Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT Part No. 70458301ENR7
Models
Prepurge
Time (seconds)
Trial for Ignition
(seconds)
Reset Lockout
Condition By:
CE and
Australia
18 10 025, 030, 035, 055:
Press reset button on
rear of machine
T30, T45: Press lighted
reset button in rear
contactor box
Models through
3/10/13
All others 1-3 10 Open loading door
Models starting
3/11/13 through
12/31/13
CE 1 10
(attempts to ignite 3
times)
For models with EO,
RE, RU or UO control
suffixes: Press start on
control keypad.
For models with all
other control suffixes:
Press and hold reset
button on junction box
until light goes out.
Models Starting
3/11/13
Non-CE and non-
Australian
1 10
(attempts to ignite 3
times)
Open loading door
Models starting
3/11/13 through
7/31/13
Australia 18 10 025, 030, 035, 055:
Press reset button on
rear of machine
T30, T45: Press lighted
reset button in rear
contactor box
Models starting 8/1/13 Australia
Models Starting
1/1/14
CE
23 23 For models with EO,
RE, RU or UO control
suffixes: Press start on
control keypad.
For models with all
other control suffixes:
Press and hold ignition
control reset button.
If the tumble dryer does not meet ANY of the listed requirements, remove tumble dryer from use. Refer to Removing Tumble Dryer
from Service section.
Required for CE Models Only
Once machine is installed, please be sure to complete the
following items:
• Review and verify machine operation with customer.
• Leave all literature and a signed Declaration of Conformity
with customer.
• Review machine warranty information with customer.