Alliance Laundry Systems HWTT20*N - Motor Operation Issues

39201 23
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
General Troubleshooting
7. Motor Does Not Run
Motor does not run.
Is electrical
power off, fuse
blown or power
cord not
plugged in?
Check laundry
room for blown or
loose fuse(s) or
open circuit
breakers.
(Washer itself
does not have an
electrical fuse.)
Yes
Is lid open or
lid switch
inoperative?
Close lid or
test switch and
replace if
inoperative.
Yes
Is
timer/control
improperly
set?
No
Reset
timer/control
or try another
cycle.
Yes
Are motor
starting
functions
inoperative; no
start or motor
hums only?
Refer to Motor
Test Procedure
section to check
start switch and
start windings.
TLW398S
No
Is
timer/control
inoperative?
Test
timer/control
and replace if
inoperative.
Yes
Is there
broken,
loose or
incorrect
wiring?
Refer to
appropriate
wiring diagram.
Yes
Refer to
appropriate wiring
diagram for
correct wiring.
Yes
Is motor dead,
won't run?
Refer to Motor
Test Procedure
section to
check switch
and windings.
Yes
Is there a bind in
upper or lower
motor bearing?
Remove belt and
determine if
motor shaft will
spin. Replace
motor if shaft is
locked up.
Yes
Is power
cord
miswired?
No
Yes
Has motor
overload
protector
cycled?
Wait two or three
minutes for overload
protector to reset. If
protector cycles
repeatedly, refer to
Washer Overheats,
Cycles On Motor
Thermal Protector,
Switch Actuator Kicks
In and Out
paragraph.
No
Yes
No
No
No
No
No