39201 91
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Troubleshooting
NetMaster Models
49. NetMaster Error Code Listing
Errors beginning with “EI” refer to NetMaster Infrared communication errors. Errors beginning with “EC”
refer to NetMaster card reader errors. All other errors refer to electronic control errors.
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
WARNING
Display Description Cause/Corrective Action
EI:00 General Communications
Error
Communication problem. Re-aim Micro-wand and try again.
EI:01 Bad Transmission Communication problem. Re-aim Micro-wand and try again.
EI:02 Device Timeout Communication problem. Re-aim Micro-wand and try again.
EI:03 Invalid Command Code Wrong machine type. Before downloading, ensure data is for
current machine type.
EI:04 Expecting Upload Request Communication problem. Re-aim Micro-wand and try again.
EI:05 Invalid or Out-of-Range
Data
Wrong machine type. Before downloading, ensure data is for
current machine type.
EI:06 Invalid Data Code Wrong machine type. Before downloading, ensure data is for
current machine type.
EI:07 Error Writing to RTC Control failure. Control may need to be replaced.
EI:08 Error Writing to EEPROM Control failure. Control may need to be replaced.
EI:09 CRC-16 Error Communication problem. Re-aim Micro-wand and try again.
EI:0A Invalid Machine Type Wrong machine type. Before downloading, ensure data is for
current machine type.
EI:0F Invalid Wakeup or IR
Disabled
Communication problem or IR is disabled. Manually enable IR on
control/Re-aim Micro-wand and try again.
EC:00 General Communication
Error
Communication problem. Try card again.
EC:02 Timeout Error Communication problem. Try card again.
To Next Page
Loading...
