Alliance Laundry Systems HWTT20*N - Washer Stops in Cycle; Quits after a Couple Loads; Is Intermittent

39201 29
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
General Troubleshooting
13. Washer Stops In Cycle; Quits After A Couple Loads; Is Intermittent
Washer stops in cycle, quits
after a couple loads or is
intermittent.
Is belt tacky,
not allowing
proper slip?
Check belt and
replace if
defective.
Yes
Is belt tension
too great, not
allowing
proper slip?
Make sure idler
spring is
properly
connected.
Yes
Is
timer/control
inoperative?
No
Test
timer/control
and replace if
inoperative.
Yes
Are motor
switch
functions
inoperative?
Refer to Motor
Test Procedure
section to check
switch
functions.
TLW401S
No
Has motor
overload
protector
cycled?
Wait two or three
minutes for
overload protector
to reset. If protector
cycles repeatedly,
refer to
Washer
Overheats, Cycles
On Motor Thermal
Protector, Switch
Actuator Kicks In
and Out
paragraph.
Yes
Has brake,
transmission
or motor
locked up and
will not turn?
Check that all
these
components
are able to
move freely.
Yes
Refer to
appropriate wiring
diagram.
Yes
Is there
broken, loose
or incorrect
wiring?
Yes
No
No
No
No