Product Description
2
Key Features
The AT-FS704 unmanaged Fast Ethernet switch has the following features:
❑
IEEE 802.3 and 802.3u compliant.
❑
Store-and-forward at full wire speed to support rate adaptation and
ensure data integrity.
❑
Auto-negotiation for any port. This allows for auto-detection of speed
(10/100 Mbps) and duplex mode (full- or half-duplex), thereby
providing automatic and flexible solutions in your network
connections.
❑
Auto polarity detection for correction of incorrect polarity on the
receive twisted pair at each port.
❑
Data packet forwarding and filtering at full wire speed.
❑
8 K active MAC address entry table per device with self learning and
table aging.
❑
4 MB packet buffer per device.
❑
Uplink/MDI (Media-Dependent Interface) port for uplink to another
switch, hub or repeater. Please note that if you are using the uplink
port, you will be unable to use Port 1, as these two ports are logically
connected.
To Next Page
Loading...
Need help?
General
