AT-RS710TX, AT-RS718TX, and AT-FS708 Switches Installation Guide
7
More details are provided in Chapter 2.
MDI Button
The following ports associated with MDI buttons:
❑ Port A on the AT-RS710TX and the AT-RS718TX
❑ Port 8 on the AT-FS708
Specific ports associated with MDI buttons are described in Table 4. The
buttons give you the flexibility of using a straight-through cable to connect to a
hub or another switch, or to any DTE such as an end station or a server.
Table 3: LED Status
LEDs Color Description
100M Green
Off means the bandwidth is 10 Mbps.
On means the bandwidth is 100 Mbps.
Applies to Ports A and B on the AT-RS710TX and the
AT-RS718TX and to all ports on the AT-FS708.
COLLISION Amber
Blinking indicates the port is detecting a collision.
Applies to half duplex transmission only. Intermittent
collisions are normal.
FULL DUPLEX Green
On indicates full duplex transmission.
LINK/ACTIVITY Green
On indicates a valid physical link on the port.
Blinking indicates data is being transmitted.
LINK and ACTIVITY are two separate LEDs on the
AT-FS708.
POWER Green
Off means there is no power to the switch.
On means there is power to the switch.
To Next Page
Loading...
