11
Chapter 2
Installation
Before you Proceed
Before installing the switch, make sure you read “Electrical Safety and
Installation Requirements” on page iii.
Verifying Package Contents
Make sure that the package includes the following items:
❑ One AT-RS710TX, AT-RS718TX, or AT-FS708 switch
❑ One AC power cord
❑ Two rackmounting brackets
❑ Four self-adhesive rubber feet
❑ Four ovalhead screws with washers and eight flathead screws
❑ Warranty card
❑ This installation guide
If any of the above items is damaged or missing, contact your representative
immediately.
To Next Page