AT-RS710TX, AT-RS718TX, and AT-FS708 Switches Installation Guide
15
Full/Half Duplex Setting
You can configure each 10 Mbps port on the following switch models for full or
half duplex transmission:
❑ AT-RS718TX, ports 1-16
❑ AT-RS710TX, ports 1-8
The DIP switches are located in the rear panel and are set in the factory for half
duplex. Each numbered DIP switch corresponds to the 10 Mbps port on the
front panel. Figure 8 shows a close-up of the AT-RS710TX’s rear panel as an
example.
Figure 8: DIP Switches for Full or Half Duplex Transmission
To configure, push the DIP switches up position for half duplex, or push them
down for full duplex.
Note
All ports on the AT-FS708 model automatically sense full or half
duplex; therefore, this model does not have DIP switches.
12345678
HALF DUPLEX
FULL DUPLEX
To Next Page
Loading...
