Installation
14
MDI Button Setting
Specific ports on the switch are associated with MDI buttons for uplink (hub or
switch) or DTE (end station or server) connectivity. If you are using these ports,
use Table 5 to guide you on how to use the MDI buttons on your switch.
Table 5: Using the Media-Dependent Interface Button
If Your Switch Model
and
Ports Are
Use this MDI
Button
Position
Use This
Cable
To Connect to
This Device
AT-RS710TX:
Port A
(100 Mbps) and
Port 8
10 Mbps)
In
(To HUB)
Out
(To PC)
Straight-
through
Switch or hub
DTE (end station or server)
AT-RS718TX:
Port A
(100 Mbps) and
Port 16
10 Mbps)
In
(To HUB)
Out
(To PC)
Straight-
through
Switch or hub
DTE (end station or server)
AT-FS708:
Port 8
(100 Mbps)
In
(To HUB)
Out
(To PC)
Straight-
through
Switch or hub
DTE (end station or server)
To Next Page
Loading...
