AT-S63 Management Software Command Line Interface User’s Guide
105
DISABLE INTERFACE LINKTRAP
Syntax
disable interface=
port
linktrap
Parameter
port Specifies the port on which you want to disable link
traps. You can specify more than one port at a time.
You can specify the ports individually (for example,
5,7,22), as a range (for example, 18-23), or both (for
example, 1,5,14-22).
Description
This command disables link traps on the port.
Note
SNMP must be enabled and correctly configured to generate traps
and, therefore, allow you to disable link traps on a specific port.
Example
The following command disables link traps on port 21:
disable interface=21
To Next Page
Loading...
