Chapter 19: MSTP Commands
242
SHOW MSTP
Syntax
show mstp [portconfig=
ports
] [portstate=
ports
] [msti] [cist]
[mstivlanassoc]
Parameters
portconfig Specifies a port. You can specify more than one port at
a time. For a list of the MSTP information displayed by
this parameter, refer to Description below.
portstate Specifies a port. You can specify more than one port at
a time. For a list of the MSTP information displayed by
this parameter, refer to Description below.
msti Displays a list of the MSTIs on the switch and their
associated VLANs. The list does not include the CIST.
cist Displays the CIST priority and the VLANs associated
with CIST.
mstivlanassoc Displays a list of the MSTIs on the switch, including the
CIST, and their associated VLANs.
Note
You can specify only one parameter at a time in this command.
Description
This command displays MSTP parameters. For definitions of the MSTP
terms used below, refer to Chapter 17, “MSTP” in the AT-S63 Management
Software Menus Interface User’s Guide.
Entering SHOW MSTP without any parameters displays the following
MSTP settings:
❑ MSTP status
❑ Force version
❑ Hello time
❑ Forwarding delay
❑ Maximum age
❑ Maximum hops
To Next Page
Loading...
