Chapter 12: File Download and Upload Commands
154
LOAD
Syntax
load method=tftp|xmodem|remoteswitch destfile=
filename
server=
ipaddress
srcfile|file=
filename
switchlist=
switches
verbose=yes|no|on|off|true|false
Parameters
method Specifies the method of download. Options are:
tftp Specifies a TFTP download. To use
this option, there must be a
network node with TFTP server
software. The file to download
onto the switch must be stored on
the TFTP server. You can use the
TFTP option from either a local or
Telnet management session.
xmodem Specifies an Xmodem download
via a local management session.
This download method is only
available from a local
management session.
remoteswitch Indicates that the download will
be from a master switch to other
switches in an enhanced stack.
This option must be used with the
SWITCHLIST option. This option
can only be used from a local or
remote management session of a
master switch.
destfile Specifies the destination filename for the file. This is
the name under which the file is to be stored on the
switch. The name can be from 1 to 15 alphanumeric
characters, not including the three-letter extension.
If the name includes spaces, enclose it in double
quotes. If you are downloading an AT-S63 software
image, the name must be “ATS63.IMG”.
server Specifies the IP address of network node containing
the TFTP server software. This parameter is required
for a TFTP download.
To Next Page
Loading...
