Allied Telesis AT-S63 User Manual

AT-S63 Management Software Command Line Interface User’s Guide
91
SET DATE
Syntax
set date= dd-mm-yyyy
Parameter
date Specifies the date for the switch in day-month-year
format.
Description
This command sets the date on the switch. You can use this command to
set the switch’s date if you are not using an SNTP server.
Note
The system’ date, when set with this command, is lost whenever you
power cycle or reset the switch. To avoid having to reenter the date,
you can configure the SNTP client software so that the switch
automatically obtains this information from an SNTP server.
Example
The following command sets the switch’s date to December 11, 2004:
set date=11-12-2004

Allied Telesis AT-S63 Specifications

General

Brand	Allied Telesis
Model	AT-S63
Category	Software
Language	English