AT-S63 Management Software Command Line Interface User’s Guide
319
SET VLAN
Syntax
set vlan=
name
[vid=
vid
] type=portbased
Parameter
vlan Specifies the name of the dynamic GVRP VLAN you
want to convert into a static VLAN. To view VLAN
names, refer to “SHOW VLAN” on page 320.
vid Specifies the VID of the dynamic VLAN. To view VIDs,
refer to “SHOW VLAN” on page 320. This parameter
is optional.
type Specifies the type of static VLAN to which the
dynamic VLAN is to be converted. There is only one
option: PORTBASED.
Description
This command converts a dynamic GVRP VLAN into a static tagged
VLAN. You can perform this command to permanently retain the VLANs
the switch learned through GVRP.
Note
This command cannot convert a dynamic GVRP port in a static VLAN
into a static port. For that you must manually modify the static VLAN,
specifying the dynamic port as either a tagged or untagged
member of the VLAN.
Example
This command changes the dynamic VLAN GVRP_VLAN_22 into a static
VLAN:
set vlan=gvrp_vlan_22 type=portbased
To Next Page
Loading...
Need help?
General
