— TPS to transmission bracket M6 bolts—10–13 N•m (84–120 lb inch);
1
/
4
-20 bolts—12–15 N•m (108–132 lb inch)
• Cooler Fluid Lines and Air Hose for:
— No leaks
— Connection tightness
— Correct routing
• Throttle sensor for:
— Proper adjustment
— Correct routing of cable and harness
• Driveline for:
— Proper indexing of universal joints
— Proper drive shaft angles
— Driveline backlash
— Lubricated universals and slip-joints
• Hydraulic System for:
— Recommended fluid—TranSynd™ or DEXRON
®
-III
— Correct fluid level in transmission
— Dipstick correctly calibrated—refer to Figure 2–2
— Fill tube tight
— Fill tube cap tight
— Breather clean and free of restrictions
— No fluid leaks during operation
• Instruments and Electrical Equipment for:
— Proper wiring and electrical connections
— Instruments, gauges, and lights work correctly
— Shift Selector display is on and CHECK TRANS light is off
— Fluid temperature gauge
• Power Takeoff—if installed—for:
— Controls connected and operative
— Correctly coupled to driven equipment
— Lubrication line correctly installed and routed—if used
77
To Next Page
Loading...
