5–5. INSPECTING CONTROLS
a. Inspection. Inspect the following and correct any faulty conditions:
• Shift selector:
— improper operation
— poor electrical connections
— improper harness routing
• Cab and chassis wiring harness:
— poor electrical connections
— frayed insulation
— wiring damage
• Throttle sensor components, if present:
— freedom of movement
— improper routing
— bellows damage
— improper or loose cable mounting
• PTO controls, if present:
— damage
— wear
— improper operation
— lubrication
— electrical harness connections and wiring damage
• Temperature gauge:
— capillary tube damage (if used)
— sensor damage
• Retarder Controls:
— damage
— wear
— poor electrical connections
— frayed insulation
— wiring damage
• Fluid pressure gauge tubing:
— damage
— kinks
— improper routing
65
To Next Page
Loading...
