6–60 Copyright © 1998 General Motors Corp.
WTEC II ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL
Main code 36 indicates the system has detected a mismatch between the ECU hardware and the ECU EPROM
software or that there is a TransID (TID) problem.
Active Indicator Clearing Procedure:
•
Power down
Troubleshooting:
1. Correction for subcode 36 00 requires the installation of EPROM software that is compatible with
the ECU hardware involved. (If a different EEPROM calibration is required, update the ECU
hardware to be compatible.)
Main
Code
Subcode Meaning
36 00 Mismatch between ECU hardware and software
CAUTION:
Static electricity can destroy the EEPROM. If the ECU must be opened, use the Anti-Static
Wrist Strap BT 8639-B to prevent a static electricity discharge to the EEPROM.
CODE 36 XX — HARDWARE AND SOFTWARE NOT COMPATIBLE
To Next Page
Loading...