4 - English - Translated from the original language Manual 6-1624970M - rev. 1 - 11/01/2023
DANGER
RISK OF ELECTRIC SHOCK AND/OR FIRE
• Do not expose the equipment to liquid substances.
• Do not exceed the temperature and humidity ranges specified in the technical data and leave the slit area
ventilated.
• Only use compatible accessories as indicated in the user manual.
• Use only cables of appropriate cross-section as indicated in the section "GUIDELINES FOR ELECTRICAL
CONNECTIONS". Tighten the connections in accordance with the technical specifications for the tightening
torques and verify the correct wiring.
• Electrical cables must not come into contact with parts that can heat up and with parts of the automation
in motion.
Failure to comply with these instructions will result in death or serious injury.
DANGER
RISK OF IMPACT, CRUSHING, HOOKING AND ENTRAPMENT
• The door can be automated only if in good condition and if it complies with EN 12604.
• Take all appropriate precautions in accordance with EN 12453.
• Read the information in the section "GUIDELINES FOR DOOR MOTORS".
Failure to comply with these instructions will result in death or serious injury.
WARNING
RISK OF OVERHEATING AND/OR FIRE
• Do not use with loads other than those indicated in the technical data.
• Do not exceed the maximum current allowed; in case of higher loads use a contactor of suitable power.
• Power lines and output connections shall be suitably wired and fused when required by national and local
regulatory requirements.
Failure to comply with these instructions may result in death, serious injury or damage to
equipment.
WARNING
INCOMPATIBILITY OF LEGISLATION
• Ensure that all equipment used and systems designed comply with all applicable local, regional and
national regulations and regulations.
Failure to comply with these instructions may result in death, serious injury or damage to
equipment.
WARNING
• The reported data have been compiled and checked with the utmost care, however the manufacturer of
the partly completed machine cannot assume any responsibility for any errors, omissions or approximations
due to technical or graphic requirements.
• The automation manufacturer recalls that this manual does not replace what is required by the rules that
the manufacturer of the motorized door/gate is required to comply with.
The manufacturer of this partly completed machine assumes no liability for any consequences arising from the use
of this material.
To Next Page
Loading...
Need help?
General
