Wireless-N Broadband Router User Guide
Points should use different Channels.
2. Connect LAN Cables
Use standard LAN cables to connect PCs to the Switching Hub ports on the Wireless-N
Broadband Router. Both 10BaseT and 100BaseT connections can be used simultaneously.
3. Connect ADSL Cable
Connect the DSL or Cable modem to the WAN port on the Wireless-N Broadband Router.
Use the cable supplied with your DSL/Cable modem. If no cable was supplied, use a stan-
dard cable.
4. Power Up
Connect the supplied power adapter to the Wireless-N Broadband Router. Use only the
power adapter provided. Using a different one may cause hardware damage.
5. Check the LEDs
• The Power LED should be ON.
• The LAN LED should be ON (provided the PC is also ON.)
• The Wireless LED should be ON if Wireless PC is connected.
• The WAN LED should be ON if ADSL line is connected.
• The Internet LED may be OFF. After configuration, it should come ON.
For more information, refer to Front-mounted LEDs in Chapter 1.
8
To Next Page
Loading...