Alluris FMI-S Series - Reviewing Statistical Measurement Results

FMI-B
FMI-S
Bedienungsanleitung
Operation manual
Notice d’utilisation
Instrucciones de servcio
Istruzioni per l’uso
www.alluris.de
Page 22 of 34
4.4.5. Displaying statistics
After having finished a measurement, you may review the statistical
results of the measurement. By pressing the S-key you call the diffe-
rent statistical values (see adjacent chart).
Standard mode is set:
last measured value
S
S
S
S
S
S
S
S
S
S
NN
Mem
Peak modes are set:
Peak (last measured value)
Mem
Peak
NNN
Peak + (positive peak value)
NN
Mem
Peak – (negative peak value)
Mem
Peak
NNNN
Statistical values
Maximum value
in positive sense
Mem
NNNNN
Minimum value
in positive sense
Mem
NNNN
Maximum value
in negative sense
Mem
NNN
Minimum value
in negative sense
Mem
NN
Average value
(arithmetic average) Avg
Mem
NNNN
Avg
N
Standard deviation Dev
Mem
NNNN
Dev
Displaying the statistics sequence