FMI-B
FMI-S
Bedienungsanleitung
Operation manual
Notice d’utilisation
Instrucciones de servcio
Istruzioni per l’uso
www.alluris.de
Page 23 of 34
4.4.6. Recalling memory
All recorded values can be downloaded by software in addition to the
displayed statistical values (series FMI-B30 and FMI-S30 and higher).
If the device has not been turned off this can be done even after ha-
ving finished a measurement.
With instruments series FMI-B measurements can be carried out
without connection via USB cable. The device can be subsequently
connected to the PC and data can be read out then by software.
Devices of series FMI-S have to be connected to PC already during
measurements.
4.4.7. Clearing memory
You have three possibilities to clear the memory:
• Single peak values can be deleted by pressing the O-key. The dis-
play shows „O.O“ when the value is deleted.
• By pressing the O-key for 2 seconds all recorded values (both sta-
tistical values and measured values) will be entirely cleared.
• Turning the instrument off deletes the memory content (both sta-
tistical values and measured values) completely.
press 2 seconds
=
all stored values
deleted
Display:
any value
idle
=
memory cleared
N
Peak
Mem
>
<
Deleting all values stored values
Display:
peak value
delete rst peak value
deleted
S
select
next peak value
>
<
Deleting single stored values
To Next Page
Loading...
Need help?
General
