Allworx 9224 - Release; Park; Info; Speaker

Phone Guide – 9224
300 Main Street • East Rochester, NY 14445 • Toll Free 1-866-ALLWORX • 585-421-3850 • www.allworx.com
© 2008 Allworx. All rights reserved
Version 1. Revised: September 9, 2008
Page 7
6. If you want to cancel the transfer, press the RELEASE button. To return to the original caller, press the
Call Appearance PFK where the call is currently being held.
4.5 Release
The RELEASE button is used to hang up an active call or to abort a new call setup, such as the middle of a
transfer operation.
4.6 Park
PBX Behavior on a call appearance
• To park an active call, press the PARK button.
• The phone displays for 3 seconds the parking orbit (701 - 709) of where the call is parked.
Key System Behavior on an outside line
• To place an active call in a “system-wide hold”, press the PARK button. Any phone with a PFK for this
outside line will be able to retrieve the call.
4.7 Info
The INFO button is used to get information regarding the other buttons on your phone. For example, you can
use the INFO button to determine the numbers that have been programmed for each speed-dial button.
To use this feature:
1. Press the INFO button.
2. Press any of the other buttons on the phone.
3. The screen will display a brief description of the selected button.
4. Press the INFO button a second time or let the screen time out to exit the description screen.
4.8 Speaker
Press the SPEAKER button for hands-free use of the phone.
If you are already using the handset, you can press the SPEAKER button and then place the handset on hook. Take
the handset off the hook to continue using it again. When you are finished with the call, press the SPEAKER button to
hang up.
Note: If you are using a headset, use the SPEAKER button to activate it. You will not be able to use the
speakerphone while using a headset unless a headset button is programmed by the system
administrator (see Section 5.4).
4.9 Mute/DND
Mute a Call
During a call, you can press the MUTE/DND button to turn off the microphone in the handset, speakerphone,
or headset. The light on the MUTE/DND button is red when the phone is muted.
Prevent Incoming Calls using Do Not Disturb (DND)
1. When not on a call, press the MUTE/DND button.
2. The light on the MUTE/DND button will appear amber.
3. With Do Not Disturb enabled, your phone will not ring. All calls will follow the next step in your active
call route.
4. Press MUTE/DND to turn Do Not Disturb off your phone. The light on the MUTE/DND button will turn
off.