Phone Guide – 9224
300 Main Street • East Rochester, NY 14445 • Toll Free 1-866-ALLWORX • 585-421-3850 • www.allworx.com
© 2008 Allworx. All rights reserved
Version 1. Revised: September 9, 2008
Page 13
2. The button color change to solid red (logged out of Queue).
Placing a Call in a Queue
Calls can be put in a Queue either by dialing an extension routed to a Queue from an Auto Attendant or by
the following steps:
To place a call in a Queue:
1. Press the TRANSFER button.
2. Dial 440# (# representing Queues 0 through 9) or an extension that is routed to a Queue.
Retrieving a Call from a Queue
Call Queues are created and programmed by your System Administrator. There are two ways to retrieve a
call from a Queue:
• Dial extension 441# (# representing Queues 0 through 9).
• The System Administrator can define the PFKs on your phone as Queue Appearances for one or more
Call Queues:
The Queue PFK may be in one of several states:
o Red means you are currently logged out of the Queue.
o Off (not lit) means you are logged into the Queue but there are no calls waiting in the Queue.
o Flashing green means there is at least one call in the Queue and will flash on all phones that are
logged in.
When the Queue PFK light is flashing, you will be able to pick up the call by pressing the PFK or
SPEAKER button for hands-free mode, or by using your handset or headset and pressing the PFK.
If Music on Hold is enabled for your company’s system, queued callers will hear music.
6.10 Call Forwarding
Dialing 45 + an extension will forward any call that come into the phone to that extension.
To disable Call Forwarding for the phone, dial extension 450.
6.11 Paging Zones
Dialing 46# (# representing a Paging Zones 0 through 9) on the phone will broadcast audio to any other
phones that are members of the Paging Zone, which is set up by the System Administrator.
6.12 Conference Center
The Conference Center is an optional feature. Note: It is not available for the Allworx 10x.
There are four Conferences Bridges on the 24x and one Conference Bridge on the 6x that support up to 8
callers. A Conference can be scheduled using the directory page but can also be held without scheduling.
Callers can join a Conference by dialing extension 408 or by being transferred to the extension 408 by another
user. An Auto Attendant shortcut can be setup by the System Administrator to access the Conference Center.
A Conference ID and password are required in order to enter the conference.
Note: For more information refer to the Allworx User’s Guide found on the website at
www.allworx.com/support/downloads/default.asp.
The 24x supports up to 4 simultaneous conferences while the 6x supports only one conference. Default
Conference IDs and Pins for unscheduled conferences are shown in the table below:
To Next Page
Loading...
