Allworx 9224 - Chapter 4 Operation; 4.1 Audio Path Options; 4.2 Appearance PFKs

Phone Guide – 9224
300 Main Street • East Rochester, NY 14445 • Toll Free 1-866-ALLWORX • 585-421-3850 • www.allworx.com
© 2008 Allworx. All rights reserved
Version 1. Revised: September 9, 2008
Page 19
7.5 Clear Call History
The phone retains the history of your calls up to 99 calls. You can clear your call history by using the following
steps:
1. Select the CONFIG soft key.
2. Scroll down and highlight Clear Call History.
3. Press the Select button .
4. Select the YES soft key to clear call history OR select NO to cancel.
7.6 Refresh Directory
If new users or extensions have been set up on the Allworx server, the on-phone directory will automatically be
updated after some delay. The directory may be updated immediately using the following procedure:
1. Select the CONFIG soft key.
2. Scroll down and highlight Refresh Directory.
3. Press the Select button .
4. Select the EXIT soft key to exit the Refreshing the Directory screen.
7.7 Network Settings
Warning: Do not make any changes to your network settings unless instructed by your System
Administrator.
1. Select the CONFIG soft key.
2. Scroll down and highlight Network Settings.
3. Press the Select button .
a. DHCP – Allows the phone to extract its configuration from the server.
i. Enabled (Default)
ii. Disabled
b. VLAN – Allows the phone to stay on the same network without any hardware reconfiguration.
i. Enabled
ii. Hub Debug Mode
iii. Disabled (Default)
c. Auto NAT – Setting for a remote phone behind a firewall. See the System Administrator.
i. On
ii. Off
d. Remote Plug ‘n’ Play – Key used to set up a remote phone. See the System Administrator.
e. Edit Boot Server IP – The WAN IP address the server is using for the setup of a remote phone.
f. Edit Time Server IP – Option to change the Time Server the phone is logged into.
g. Edit Contact Serv IP – May be required for remote phones connected via MPLS networks. See
the System Administrator.
h. Edit Phone IP
– Option will appear if DHCP is disabled. Allows the manual entry of the phone’s
IP.
i. Edit Netmask IP – Option will appear if DHCP is disabled. Allows the manual entry of the
Netmask IP.
j. Edit Gateway IP – Option will appear if DHCP is disabled. Allows the manual entry of the
Gateway IP.