Step2
Step3
Check the running status of the system in “Step 3”.
If the operation is normal as described in “Step3”, please remember to deactivate
the “Charging/Discharging Setting” by clicking “OFF” and save the changes.
Select “ON” to Charge Batteries from Grid”
please set the “Charging period 1” for the time and the SOC
would be 100 under this operation.
The relative value should be like this:Load = PV ± GRID –
Battery
Battery should be in charging status.PV arrow should be as
the picture shows.±: >>absorbing from grid: +; << feed-in to
grid:-
If not correct, please check the CT or meter installed direction
of both grid and PV side
To Next Page
Loading...
