4
We reserve the right to modify technical specifications without prior notice.
UK830532/200610 © Alpha-InnoTec GmbH
Intended use
The unit may be used only for the intended use. This
means:
•
for heating.
•
for heating hot water.
The unit may be operated only within its technical pa-
rameters.
Overview “Technical data/scope of delivery”.
NOTICE.:
Notify the responsible power supply com-
pany of the use of a heat pump or heat
pump system.
CAUTION!
The unit is not suitable for use in IT net-
work systems.
Exclusion of liability
The manufacturer will not be liable for damage resulting
from unauthorized use of the unit.
The manufacturer’s liability will also be voided in the fol-
lowing cases:
•
if work is performed on the unit and its compo-
nents in a manner that does not comply with the
terms of this operating manual;
•
if work is performed on the unit and its compo-
nents in an improper manner;
•
if work is performed on the unit that is not de-
scribed in this operating manual, and this work
was not expressly approved in writing by the man-
ufacturer;
•
if the unit or components in the unit are modied,
redesigned or removed without the express writ-
ten permission of the manufacturer.
EC conformity
The unit bears the CE mark of conformity.
EC declaration of conformity
Safety
The unit is operationally safe when used for the intend-
ed purpose. The construction and design of the unit con-
form to the state of the art, all relevant DIN/VDE regu-
lations and all relevant safety regulations.
Every person who performs work on the unit must have
read and understood the operating manual prior to
starting any work. This also applies if the respective per-
son has already worked with such a unit or a similar unit
or has been trained by the manufacturer.
Every person who performs work on the unit must com-
ply with the applicable accident prevention and safety
regulations. This applies in particular to the wearing of
personal safety gear.
DANGER!
Unit operates under high electric voltage!
DANGER!
Danger of fatal injury due to electric
current!
Electrical connections may be installed
only by qualied electricians.
Before opening the unit, disconnect the
system from the power supply and secure
it from being switched back on!
CAUTION!
If using the unit in 3~230V systems, please
note that the residual-current circuit
breaker (RCCB) used must be AC-DC sen-
sitive.
DANGER!
Only qualied technicians (trained heat-
ing, cooling, refrigerant and electrical
technicians) may perform work on the
unit and its components.
WARNING!
Observe safety labels on and in the unit.
To Next Page
Loading...
Need help?
General
