SERIES 96 RAMPING MODBUS REGISTER NUMBERS
Start Profile4002
Start Step4001
Start File4000
Hold Profile1210
Resume Profile1209
(Write Only)
Parameter
Registers
Relative
Profile State5013
Rate5012
End Set Point5011
Jump Count5010
Current Set Point5009
Seconds5008
Minutes5007
Hours5006
Event Output5005
Wait for Deviation
(process input) 4
5004
Wait for Event Input 45003
Step Type5002
Step5001
File5000
Registers (Read Only)
Parameter
Current Profile
Relative
Note: Data to be written to registers that are unavailable for a particular step type will be ignored.
Register is only available if step type is set to End.
6
Register is only available if step type is set to Jump.
5
Register is only available if step type is set to Soak.
4
Register is only available if step type is set to Set Point.
3
Register is only available if program type is set to Rate.
2
Register is only available if program type is set to Time.
1
Register is disabled or unavailable.
*
5227521452015188517551625149513651235110509750845071505850455032End T
e 6
5226521352005187517451615148513551225109509650835070505750445031Jum
Count 5
5225521251995186517351605147513451215108509550825069505650435030Jum
Ste
5
5224521151985185517251595146513351205107509450815068505550425029Jum
File 5
5223521051975184517151585145513251195106509350805067505450415028
Waitfor Deviation
Process In
ut
4
5222520951965183517051575144513151185105509250795066505350405027
Waitfor Event
In
ut 4
5221520851955182516951565143513051175104509150785065505250395026EventOut
ut 2, 3 or 4
5220520751945181516851555142512951165103509050775064505150385025Rate 2 and 3
5219520651935180516751545141512851155102508950765063505050375024Seconds 1 or 4
5218520551925179516651535140512751145101508850755062504950365023Minutes 1 or 4
5217520451915178516551525139512651135100508750745061504850355022Hours 1 or 4
5216520351905177516451515138512551125099508650735060504750345021End Set Point
5215520251895176516351515137512451115098508550725059504650335020Ste
T
e
File 2
Step 8
File 2
Step 7
File 2
Step 6
File 2
Step 5
File 2
Step 4
File 2
Step 3
File 2
Step 2
File 2
Step 1
File 1
Step 8
File 1
Step 7
File 1
Step 6
File 1
Step 5
File 1
Step 4
File 1
Step 3
File 1
Step 2
File 1
Step 1
Parameter
Note: For absolute numbers, add 40001 to each relative
number.
Profile Definition Registers
(Read and Write)
ALPHA OMEGA INSTRUMENTS CORP. Instruction Manual
Series 800/850 Thermoelectric Cooler Controller Page 111