Alpine A110 - Page 25

USING VOICE RECOGNITION
1
General information - 23
Controlling navigation with
voice recognition
There are several ways to enter a
destination using the voice command
included in your multimedia
system.
«Destination»
Enter a complete address using the
voice command.
Press the voice command button
to display the voice command main
menu.
After the sound signal, say "Go to"
then state the complete destination
address (number, street name,
destination town/city, neighbourhood).
The system will show the address it
has understood, then you can confirm
your destination to begin the guided
navigation.
«Home»
To retrieve your home address using
the voice command.
Press the voice command button
to display the voice command main
menu.
After the sound signal, say "Go home".
The system will indicate your pre-
recorded home address. Confirm your
destination to begin guidance.
«Work»
To retrieve your work address using
the voice command.
Press the voice command button
to display the voice command main
menu.
After the sound signal, say "Go to
work".
The system will indicate your pre-
recorded work address. Confirm your
destination to begin guidance.
Note: to use the "Go home" or "Go to
work" voice function, you must first
save an address.
If no address is registered, the
multimedia system suggests that you
enter an address.
For further information on saving a
home or work address, see the section
on "Navigation settings".